Check valve machining: seat, shaft and alignment

When a pump stops, the column of fluid it has just delivered tends to flow back towards it. Preventing this is the job of the check valve, also known as a non-return valve: it allows flow in one direction only and closes by itself as soon as the flow reverses. That automatic response protects the integrity of pumps and compressors, keeps pipelines from draining and shields the network from the pressure surges caused by a pump shutdown.
Unlike an isolation valve, no one operates it. Its behaviour is governed by flow rate, pressure and the geometry of its parts, which is why machining determines not only whether the valve seals tightly, but also how quickly and smoothly it closes.
Types of check valve: three ways of closing
In the swing check valve, the disc hangs from a shaft located at the top of the body. The flow lifts it and, when it reverses, the disc swings through an arc until it rests on the seat. It offers an almost unobstructed bore and minimal head loss, but its long travel means it closes more slowly and is more sensitive to pressure spikes during sudden shutdowns.
The disc check valve does not swing. Instead, the closure member moves back and forth in line with the flow, guided and pushed by a spring. With a stroke of just a few millimetres, it closes practically the instant flow stops, accepts horizontal or vertical installation and, in return, offers slightly more resistance to flow.
The dual plate check valve divides the closure member into two half-discs that pivot on a central shaft, each with its own spring. By splitting the travel between two smaller parts, it achieves rapid closure with a very short wafer-type body mounted between flanges. In large diameters, this compactness translates into lower weight and less installation space.
Critical areas in check valve machining
Internal leakage at rest causes the pump to rotate in reverse or the line to lose pressure, and it almost always originates at the seat. The sealing surface requires controlled flatness and finish, and must be perpendicular to the flow axis. Where the fluid carries particles, the seat is hardfaced with Stellite and then machined to its final dimension; in other designs it is an insert ring, and the critical factor becomes the fit of its housing in the body.
The hinge shaft supports the disc throughout every opening and closing cycle. Its two housings, on opposite walls of the body, must be coaxial and positioned at the exact distance from the seat plane. If they are not, the disc makes contact on one side first, rebounds and vibrates, accelerating wear on both the shaft and the seat. Clearance also matters: too much causes impacts, and too little causes seizing.
Alignment between disc and body is the sum of the two previous factors. Seat, shaft housings and disc sealing face form a dimensional chain, and the error in each link accumulates at the final contact point. That is why we machine the seat and shaft housings from a single datum, which in large-format bodies requires machines such as our Trevisan machining centres, designed for workpieces of up to 25 tonnes, and we verify that relationship on our Zeiss coordinate measuring machine (CMM) before the part leaves the workshop.
Check valve applications in desalination, water and oil & gas
In desalination plants, check valves are installed at seawater intakes and on the discharge of high-pressure reverse osmosis pumps. Constant contact with chloride-rich brine calls for duplex and super duplex steels, and the dual plate design is the most common thanks to its compactness.
In water supply and wastewater, they protect pumping stations and large-diameter rising mains. Here the priority is behaviour at pump shutdown, as late closure is one of the most common causes of hydraulic transients in the network.
In oil & gas, they operate in process lines and on compressor discharge, under high pressures and with aggressive fluids. Inconel or Hastelloy are frequently used, along with hardfacing on sealing surfaces, which we carry out using welding procedures qualified to ASME Section IX.
Check valve components machined in Beasain
At ARRI we machine bodies, discs, shafts and seats for check valves on behalf of manufacturers working in these three sectors. If your project requires the machining of valves or components in special alloys, ARRI’s technical team can analyse your requirements and propose the most suitable solution. Contact us.




